FlushMinder Automatic Dual-Flush System DIY Complete Kit attaches to the flush handle on standard toilets. The ONE and ONLY autoflush kit that converts single-flush toilets into fully automatic dual-flush. Great Cat Potty Training Accessory. Model: ASFS-TA1

Pinned on January 13, 2018 at 3:44 pm by babyShop74

Repin
FlushMinder Automatic Dual-Flush System DIY Complete Kit attaches to the flush handle on standard toilets. The ONE and ONLY autoflush kit that converts single-flush toilets into fully automatic dual-flush. Great Cat Potty Training Accessory. Model: ASFS-TA1

NEW FlushMinder G3 model has an improved flush motor and light neutral colors. Note that negative reviewers below may not have the G3 or may not have used our online support for help.

This exclusive and innovative dual-flush toilet conversion system fits most standard lever-action toilets and is FULLY AUTOMATIC. Upon toilet use, a computerized human-presence sensor measures the “time-at-the-toilet” and then automatically activates a motorized flusher inside the tank for a #1 half-flush or #2 full-flush as required. The flush motor connects directly to the flapper valve with a second chain (included), so the regular flush handle still operates normally, plus one full flush cycle occurs weekly to keep the bowl fresh when there is no usage.

Installation and setup is quick and easy with minimal tools, NO TANK REMOVAL or advanced plumbing skills required. Runs on standard AA alkaline batteries (included) for up to 1 year or 10,000 worry-free flushes.

Saves water and improves sanitation – perfect for children, the elderly or any high-use bathroom area where flushing delinquency is a problem. Complete instructions included (see above).

Also makes a great cat potty training accessory for autoflush after use . . . see online for cat potty training aids and information, plus note the reviews and YouTube videos from customer experiences. Results can vary widely, so unit is NOT GUARANTEED for desired cat use results and specific cat potty training setup and instructions are NOT INCLUDED.

NOTE: Each sensor is precisely calibrated and tested before shipment to detect from 0 – 31.5 +/- 4.0 inches (80 +/- 10 cm). Be sure that your toilet and bathroom configuration will allow a suitable installation within this range and with no obstructions.

Additional setup information available on our website along with complete replacement parts support.

Product Features


Comments

Hockeyfreak says:

Updated review: Great customer service; prompt attention to problems. Part on order, fixing soon!! UPDATE: I have finally got around to ordering the part and will be repairing it. WaterSaver replied to every email promptly, addressed any problems I had and gave instructions, and helped me to see I was misunderstanding how to adjust the half-flush the same as the full so it would always full flush. I would use the half flush if it would remove all the urine from the bowl, but it doesn’t seem to. I’ll follow their instructions more closely when I replace the broken snap ring and see if it…

rav says:

There could be better, but there’s not.


Comments are disabled for this post.